⎝⎛178电玩城⎞⎠

Ranch
Welcome to Shandong Jiangsheng Machinery Manufacturing Co., Ltd.!
当前位置: 旋转接头 > 新闻资讯 > 技术资料 > Technical informationCurrent location: Rotary joints > News > Technical information >

Troubleshooting Rotary Joint Sub-Seat

Time: 2020-01-09 09:27 Author: admin Hits: Times
Remove the rotary joint as a whole for repair: ① Remove the flange connection bolt, open the rotary pipe joint housing, use a tool to unscrew the fastening bolt of the bellows (the bolt is a left-hand thread), and take out the bellows of the rotary joint, the graphite ring and the transmission bearing. Replace it. ② Find the leak point of the rotary joint sub-steam seat, and after confirming, clean it with an angle grinder and perform welding repair (aeration test is required after installation).
Repair conclusion: As the rotary joint is installed on the wire dryer as a whole, as long as one of the above problems occurs, the entire part must be disassembled and inspected. The inlet and exhaust gaps of the rotary joint should be filled with seals during the installation. To prevent air leakage and blow-by.
å Œé € šè · ¯æ— ‹è½¬æŽ ¥ 头
    CONTACTContact Us
    Marketing Department: 0632-5659366 5619366 5652866
    Sales Hotline: Manager Liu 18766677790 Manager Wang 18363793666
    Technical Department: 0632-5652399 Fax: 0632-5659266
    Ministry of Foreign Trade: 0632-5829399
    Email: tzjiangsheng@163.com Address: No. 52, Tengzhou Economic Development Zone
    Copyright: Shandong Jiangsheng Machinery Manufacturing Co., Ltd. Record number: Lu ICP No. 14035694
    欢乐拼三张 七乐彩 欢乐拼三张 天天电玩城